Manual de instrucciones de la serie Solis
Instrucciones
- Esfera de 24 horas del cronógrafo
- Esfera de los minutos del cronógrafo
- Esfera de los segundos del cronógrafo
- Segundero
- Manecilla de la hora
- Minutero
- Botón A
- Corona
- Corona - Primer chasquido
- Corona - Segundo chasquido
- Visor de la fecha
- Botón B
Fijación de la hora: Tira de la corona hacia fuera hasta la posición 9 cuando el segundero esté en las 12 y gírala. La manecilla de 24 horas se moverá junto con la manecilla de la hora principal.
Fijación de la fecha: Tira de la corona hasta la posición 10 y gírala. Si configuras la fecha entre las 21:00 y la 1:00, podría no cambiar al día siguiente.
Iniciar y parar el cronógrafo: Pulsa el botón A.
Reiniciar el cronógrafo: Pulsa el botón B.
Tiempos intermedios: Pulsa el botón B cuando el cronógrafo esté en marcha.
Medición de dos competidores: Pulsa A para poner el cronógrafo en marcha. Pulsa B para registrar el tiempo del primer competidor. Pulsa cuando termine el segundo competidor. Pulsa B para mostrar el tiempo final del segundo competidor. Pulsa B de nuevo para reiniciar.
Reinicio del cronógrafo: Este procedimiento se debe llevar a cabo cuando el segundero no vuelva a la posición "0" al reiniciar el cronógrafo. Tira de la corona hacia fuera hasta la posición 9. Pulsa A o B para llevar el segundero del cronógrafo a la posición "0". Para mover la manecilla del cronógrafo rápidamente hacia delante, pulsa los botones A o B de forma continua. Una vez que ambas manecillas se encuentren en la posición "0", lleva la corona a su posición normal de nuevo. Si el segundero no está en "0", no empujes la corona hacia dentro, ya que la posición en la que se encuentre se reconocerá como el nuevo "0".
Funciones del reloj solar: La esfera del reloj contiene una célula solar que convierte cualquier forma de luz en energía. Al contrario que los relojes de cuarzo, este no requiere de una pila de óxido de plata, por lo que no hay que estar pendiente de los cambios.
Función de aviso de agotamiento de la energía: Cuando el nivel de energía es bajo, el segundero empieza a moverse en intervalos de dos segundos. En este caso hay que exponer el reloj a una fuente de luz lo antes posible para cargarlo.
Carga del reloj: Expón el reloj a la luz. No lo coloques demasiado cerca de una lámpara u otras fuentes de luz que produzcan calor, ya que el exceso de este podría dañarlo.
Indicador de batería Mantén el botón B pulsado durante más de un segundo. El segundero se moverá para mostrar el nivel de batería en ese momento: 35 indica que es bajo, 40 medio y 45 alto. El segundero volverá a su posición automáticamente tras 2 segundos.
Características
- Movimiento: Cuarzo Epson VR42
- Resistencia al agua: 5 ATM/50 metros
- Funciones: Fecha
- Pila: 3023 34R / MT920
- Cristal: Mineral
- Material de la caja: Acero inoxidable 316L
- Material de la correa: Material ecológico reciclado
- Sin níquel: Sí
- Tamaño máximo de la muñeca: 19,5 cm
- Tamaño mínimo de la muñeca:13 cm
- Ancho de la correa: 18 mm
- Diámetro de la caja: 42 mm
- Diámetro de la esfera: 37,5 mm
- Grosor de la caja: 10 mm
- Altura de la corona: 4 mm
- Ancho de oreja: 20 mm
- Ancho de oreja a oreja: 47 mm
- Peso: 52 g
CÓMO CUIDAR TU RELOJ
WATER RESISTANCE
Most watches have some level of water resistance. If your watch isn’t water resistant, it may be able to handle small splashes, but don’t risk it. If it has a leather band, don’t get it wet.

1 ATM/10 metros Este reloj no puede soportar ningún tipo de contacto con el agua.

3 ATM/30 metros Este reloj puede soportar la lluvia y salpicaduras de agua sin problemas.

5 ATM/50 metros Este reloj se puede usar para actividades como ducharse o nadar.

10 ATM/100 metros Este reloj tiene la suficiente resistencia al agua como para practicar esnórquel.

Más de 20 ATM/más de 200 metros Este reloj es seguro para la práctica de cualquier actividad acuática, como el submarinismo.
How to clean your watch case
- Do not move the crown or push any buttons when your watch is in contact with water, as this may let water enter the case.
- If your watch is not water resistant, dip a cotton swab in a bowl of warm water with a drop or two of soap in. Squeeze the tip of the cotton swab to remove most of the water and gently rub the case.
- If your watch is water resistant, soak a soft cloth in a bowl of warm water with two drops of mild washing-up liquid added. Wring most of the water out of the cloth and gently rub the case with it.
How to care for your watch
- Store your watch in a dark, dry place to avoid corrosion and discolouration of the dial.
- Always replace the battery on a quartz watch as soon as it runs out. With time, an empty battery may start leaking, damaging the watch’s movement.
- Run mechanical watches at least two days a year to prevent gears and cogs from sticking.
- You should always get your watch serviced by a professional every 3 years.
GENERAL CARE
Rule of thumb: Make sure your watch is the last thing you put on and the first thing you take off.
- Take your watch off and store it safely before engaging in any activity that could damage it.
- Take it off before engaging in any activity likely to make you sweat.
- Take it off before you shower, bathe, or go for a swim.
- Take it off before cooking or cleaning.
- Take it off before you go to bed.
- Don’t expose your watch to chemicals such as cologne, sunscreen, perfume, chlorine, hair gel, etc., as these can discolour, stain, or dull surfaces.
- Try to store your watch separately in a soft enclosure to prevent scratching and rubbing.
- If your watch has closures or clasps, close these to prevent tangling.
- Keep your watch stored in a dry, dark place, and avoid heat fluctuation.
Troubleshooting & FAQ
If you take care of your watch and keep it stored correctly, you should enjoy years of timekeeping precision. But even with the best care possible, you may find that your watch needs extra attention from time to time.
Take a look at common issues with watches here. If you can’t find what you’re looking for, our great Customer Service Team is only a phone call away.
If your new watch isn’t running, make sure you’ve removed the plastic piece between the crown (the knob on the side) and the case. Remove it and push the crown into its normal position.
Check if you need to replace the battery. Some quartz watch batteries can last up to 3 years, but most batteries are only good for 2. Any local professional can do a battery replacement.
The best way to avoid water getting into the watch case is never to operate the buttons or turn or pull the crown out in wet conditions. Even if your watch is water resistant or waterproof, humidity can get into the case as these parts move. Always make sure to close the crown properly before exposing your watch to water.
If you have droplets forming on the inside of the crystal or the crystal looks foggy, open the crown and place the watch in direct sunlight with the crown facing up and the dial facing the sun. Leave it this way for a few hours. If it’s a quartz watch and it has stopped working, the movement may be damaged beyond repair. Take it to your local professional for diagnosis and repair.
This usually means that a gear inside the watch isn’t working properly even though the electronic part is working. The watch needs to be serviced to get it running again. We recommend a service check from your local professional.
This is fixed by replacing the battery. It’s caused by a feature that indicates when the battery power is low. It’s your watch’s way of telling you that the battery is losing power. Any local professional can do a battery replacement.
Using extra functions (like the chronograph) can shorten the battery’s life. To conserve power, only use these features when you need them.
Opening the watch back unnecessarily can compromise the seal of the watch and its water resistance. We recommend only replacing the battery and opening the watch when necessary. Any local professional can do a battery replacement.
The battery should last for 1-2 years. The actual time depends on how many complications (functions like the alarm and stopwatch) the watch has, how often you use them, and how old the watch is.
Dropping or hitting the display can damage the circuits. Water or even the humidity in the air can also cause corrosion. When this happens, parts of the display will not receive proper voltage and cause the digits to not display correctly. A local professional can replace the display.
This is usually a matter of calibrating the chronograph. Rarely is this a case of the watch being faulty. Manually resetting the chronograph hand to 0 should solve the issue.
This is because the analogue (the hands) and digital components of your watch are built separately. One can malfunction while the other works fine. Seek a local professional’s help for repair.
GARANTÍA DE 2 AÑOS
Para mantener la validez de la garantía, evita exponer el reloj al agua más allá del límite calculado y conserva el recibo de compra.
Otras categorías
¿Pensabas que solo vendemos relojes? Tenemos más de 6.000 productos repartidos en 21 categorías de accesorios para hombres. Aquí tienes algunas de ellas.